Large PVC Chart Stand

Cost to make is about $5.00.

Materials :

1 Jar of cement to put it together permanently.

20 ' of 3/4" pvc pipe

2- 3/4" non-threading elbow joints

4 - 3/4" non-threading T's

4 caps

Measuring tape

Hacksaw or Sawzall

Procedure:

Cut the pvc pipe into the following pieces:

2- 42” pieces (adjust this height to fit your pocket chart)

2 - 36" pieces (adjust this width to fit your pocket chart)

2 - 12" pieces

4 - 6" pieces

Connect the 2 -36" pieces, positioned horizontally, to the 2 - 42" pieces, positioned vertically, to form a tall rectangle. Use the elbow joints at the top and the T joints at the bottom. Connect the 2- 12" pieces to the bottom of the T's. Connect the remaining 2 T's to the bottom of the 2- 12" pieces. Now, connect the 4 - 6" pieces to the T's to form the legs, and connect a cap to each end. You can cement them together if you want the stand to be permanent.